Hardwood refinishing & sanding in Wills Point, TX

In Wills Point it is almost always the house. Most of the older stock in the original grid sits on pier and beam over a crawlspace, and after decades in this humidity the joists deflect and the decking works loose. New flooring laid over that will bounce and squeak exactly the same. We look underneath before quoting and price the subfloor repair as its own line so you can see what you are paying for.

Pull a corner back in a closet before you commit to anything. Houses in the original Wills Point grid from the 1910s and 1920s often have plank hardwood under wall-to-wall carpet, and what is under there changes the whole conversation. Send us a photo or let us look during the free estimate. We would rather price the right job than sell you the bigger one.

Yes. U.S. 80 runs straight from Wills Point back to our showroom at 10 Mustang Court in Forney, so this is a regular route for us. We bring samples to the home, the estimate costs nothing, and we can usually start within about two days once you approve it. The crew is ours and never subcontracted, and labor carries a one-year warranty.

You can, but the seam will show. The same species from the same era darkens at a different rate depending on light, and a fresh finish beside a fifteen-year-old one reads as new against old no matter how the stain is matched. Where a room closes off with a door, we stop cleanly at a threshold. Across an open plan, do the whole field.

Most families stay. With a waterborne finish the odor is mild and clears quickly, and we sequence the work so there is a path to a bedroom and a bathroom. Oil-modified finish is a different story: the smell is strong for several days, and households with infants or birds usually leave. Pets have to be out of the work area entirely, since paw prints in a curing finish are permanent.

Yes, within what the species allows. Red oak carries a pink undertone that fights gray stains, maple and birch blotch unless they are conditioned or water-popped first, and no stain makes a floor lighter than its own bare wood. We sand a section of your floor and lay candidate stains on it, because a sample board of someone else's oak tells you very little.